Cold-Formed Steel Shear Wall Design
John C. Huang, Ph.D., PE
This course presents structural design guidelines for cold-formed steel stud shear walls in residential and commerical buildings. The course content is based on Shear Wall Design Guide published by North American Steel Framing Alliance (NASFA). This technical document provides the minimum design requirements and the allowable shear capacities of various wall constructions. This course includes a multiple-choice quiz at the end, which is designed to enhance the understanding of course materials.
At the conclusion of this course, the student will:
To maintain the lateral stability of the buildings constructed with load-bearing steel stud walls, the design engineer often utilizes the cold-formed steel shear walls. The most common cold-formed steel shear wall constructions are:
1. Orientated strand boards (OSB) on the exterior face of the wall;
2. Steel strap X-bracing on one face or both faces of the wall; and
3. Gypsum wall boards (GWB) on both faces of the wall.
The following design issues should be considered in the design of the shear wall:
1. Axial load transfer between roof/floor diaphragm and shear wall;
2. Anchorage at the ends of the shear wall to resist uplifting force; and
3. Shear transfer along the base of the shear wall.
It is important to ensure the continuous load path as the lateral forces are transferred from the upper level to the lower level. In addition, one has to make certain there is sufficient dead load at each anchor point to resist the potential uplifting force. S/HD Holdowns or S/LTT and S/HTT Tension Ties by SIMPSON Strong-Tie Company can be used to anchor the end studs to foundation (or primary structure) in most applications.
Where steel strap X-bracing is specified, it is often necessary to provide splicing details for the strap and top track since the stock length of the steel straps and tracks are typically 10'-0". In addition, the designer shall emphasize the importance of pulling the strap tight to eliminate any slack.
In this lesson, you will be directed to the website of North American Steel Framing Alliance (NASFA) to study the Shear Wall Design Guide (1998 edition, 23 pages).
additional technical information related to this subject, please visit the following
websites or web pages:
AISI Construction - Cold-Formed Steel Design
Cold-Formed Steel Engineers Institute
Steel Stud Manufacturers Association
Shear Wall Basics
Once you finish studying the above course content, you need to take a quiz to obtain the PDH credits.
DISCLAIMER: The materials contained in the online course are not intended as a representation or warranty on the part of PDHonline.com or any other person.comanization named herein. The materials are for general information only. They are not a substitute for competent professional advice. Application of this information to a specific project should be reviewed by a registered professional engineer. Anyone making use of the information set forth herein does so at their own risk and assumes any and all resulting liability arising therefrom.